Connecting Charger To Power Supply - Stihl FSA 90 R Instruction Manual

9
7
6
8
Place the cutting attachment (4) on
N
the fanwheel (5).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
Fit the thrust washer (6) – convex
N
side must face up.
Fit the rider plate (7).
N
Block the shaft (8).
N
Screw the mounting nut (9) on to the
N
shaft counterclockwise and tighten
it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
FSA 90 R
NOTICE
Remove the tool used to block the shaft.
Removing the Metal Cutting Attachment
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
4
cutting edges.
Block the shaft.
N
5
Unscrew the mounting nut
N
clockwise.
Take the cutting attachment and its
N
mounting hardware off the
fanwheel (5) – but do not remove
the fanwheel.
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
English
2
1
15