Mounting The Drive Tube; Mounting The Loop Handle; Mounting The Deflector - Stihl FSE 60 Instruction Manual

English
WARNING
For safety reasons no other combinations are
permitted – risk of accidents.
Only mowing heads (1) may be used on trim‐
mers with a curved drive tube and loop handle.
4.2 Cutting Attachments
4.2.1 Mowing heads
1 STIHL AutoCut C 6‑2
4.3 Deflector
2 Deflector with blade, for mowing heads
4.4 Handle
3 Loop handle
4.5 Harness
4 Shoulder strap may be used
5

Mounting the Drive Tube

2
3
A
► Pull the protective cap off the drive tube.
► Push the drive tube (1) into the motor hous‐
ing (2) as far as the mark (A), turning the drive
tube back and forth at the same time.
► Tighten down the screw (3) in the housing
firmly.
28
6
6.1
4
40 mm
► Fit the loop handle (1) on the drive tube at a
1
distance A of about 30 cm from the control
handle (2).
► Insert the hex nut (3) in the loop handle (1).
► Squeeze the ends of the clamp together, fit
the M6x40 screw (4) with washer (5) from the
other side and tighten down firmly.
6.2
► Loosen the screw (4).
A
► Move the loop handle (1) along the drive tube
to the required position – tighten down the
screw (4) firmly.
7
► Push the deflector (1) over the clamp (2) as far
as stop.
5 Mounting the Drive Tube

Mounting the Loop Handle

Mounting the Loop Handle
A
1
5
3
Adjusting Loop Handle to Most
Comfortable Position

Mounting the Deflector

2
1
2
0458-282-9821-C