Replace Hcm; Replace Adm; Software Update Procedure - Graco Reactor 2 H-30 Repair Parts

Repair

Replace HCM

HCM
Replace Replace HCM
1. Follow Before Beginning Repair, page
2. Open the electrical enclosure and disconnect all
cables from the HCM (603).
3. Remove the nuts (610) and HCM (603).
4. Set rotary switch.
Figure 12 Replace HCM
HCM HCM HCM Rotary Rotary Switch Rotary Switch Positions Switch Positions Positions
0 = Reactor 2, H-30
1 = Reactor 2, H-40
2 = Reactor 2, H-50
3 = Reactor 2, H-XP2
4 = Reactor 2, H-XP3
70

Replace ADM

Replace Replace
50. 1. Loosen four screws (142) on the inside of the
electrical enclosure door. Lift up and pull out to
remove ADM (140).
2. Disconnect CAN cable (622).
3. Inspect ADM (140) for damage. Replace if
necessary.
4. Update software by installing an upgrade token
into ADM and cycling system power. Wait until
the update is complete before removing the
token and restarting the system.
Figure 13
Software Update
Software Software
Repair kit GCA modules are shipped
pre-programmed and with upgrade token (part
number 17E206). If software version upgrade is
necessary, follow the procedure in the manual
provided.
ADM
ADM
Update Procedure Procedure
Update Procedure
NOTICE
NOTICE NOTICE
334946H