Flush Gun; Clean Outside Of Gun; Clean Or Replace Front Cover And Retainer; Clean Breather Plug - Graco Fusion CS 312666F Manual

Plural component, impingement mix air purge spray gun with clearshot liquid technology

Table of Contents

Maintenance

Flush Gun

1. Follow Pressure Relief Procedure, page

17.

2. Flush with compatible solvent into a

grounded metal pail, holding a metal part of

fluid manifold firmly to side of pail. Use low-

est possible fluid pressure when flushing.

3. Follow Pressure Relief Procedure, page

17.

For a more thorough flush, a solvent flush

kit (256510 248229) is available as an

accessory.

Wipe off outside of gun with compatible sol-

vent. Use N-Methylpyrrolidone (NMP), Dyna-

solve CU-6, Dzolv, or an equivalent to soften

cured material.

CAUTION

These solvents are not recommended for

flushing; use only for cleaning.

Clean or Replace Front

Cover and Retainer

Soak front cover retainer (C) and front cover

(U) in compatible solvent. Brush or wipe clean.

Replace as needed.

Remove and clean breather plug with compati-

ble solvent.

312666F

Table of Contents