Repair Circuit Breaker Module; 50, Xp3 - Graco Reactor 2 H-30 Repair Parts

Repair
4. Accept or cancel the hose calibration.
NOTE: A temperature estimate will be displayed
NOTE: NOTE:
if the system was able to measure the hose wire
resistance.
Repair Circuit Circuit Breaker Breaker Module
Repair Repair Circuit Breaker
1. Follow Before Beginning Repair, page
2. Using an ohmmeter, check for continuity across
the circuit breaker (top to bottom). If no continuity,
trip the breaker, reset, and retest. If there still is
no continuity, replace the breaker as follows:
a. Refer to Electrical Schematics, page
b. Perform Shutdown, page
c. Refer to the circuit breaker identification table
and electrical diagrams.
d. Loosen the screws connecting the wires
to the circuit breaker that will be replaced.
Disconnect wires.
e. Pull the locking tab out 1/4 in. (6 mm) and
pull circuit breaker away from the din rail.
Install the new circuit breaker. Insert wires
and tighten down all screws.
66
Module
Module
50.
102.
48.
Table 4 4 4 H H H - - - 30, 30, H H H - - - XP2 XP2 Circuit Circuit Breakers
Table Table 30, XP2 Circuit
Ref. Ref. Ref. Size Size Size
853 (CB11) 50A, 1 pole Heated
854 (CB12) 20A, 2 pole Motor
855 (CB13) 40A, 2 pole Heater A
855 (CB14) 40A, 2 pole Heater B
855 (CB15) 40A, 2 pole Trans-
Table Table 5 5 5 H H H - - - 40, Table 40, H H H - - - 50, 40, 50, 50, H H H - - - XP3 XP3 XP3 Circuit
Ref. Size
Ref. Ref. Size Size
853 (CB11) 50A, 1
pole
859 (CB12) 20A, 3
pole
854 (CB13) 60A, 2
pole
854 (CB14) 60A, 2
pole
855 (CB15) 40A, 2
pole
Breakers
Breakers
Component Component Component Part Part Part
17A319
Hose
17A314
17A317
17A317
17A317
former Pri-
mary
Circuit Breakers Circuit Breakers Breakers
Component Part
Component Component Part Part
Heated Hose 17A319
Motor 17G724
Heater A 17G723
Heater B 17G723
Transformer 17A317
Primary
334946H