Repair; Replace The Pressuretrak Module Battery Or Fuse - Graco 17G807 Operation And Parts

Repair

Repair
Repair Repair
Replace the the PressureTrak PressureTrak Module
Replace Replace the PressureTrak
Battery or or or Fuse Fuse
Battery Battery Fuse
The battery and fuse must be replaced in a
non-hazardous location.
1. Remove the two screws (135). Carefully slide the
PressureTrak module (131) out of the housing
(132).
XP System System
XP XP System
XP-hf XP-hf System XP-hf System System
2. Disconnect the electric solenoid (7) and pressure
sensor cables (4) from the module board.
18
Module
Module
3. Take the PressureTrak module (131) to a
non-hazardous location.
4. To
battery and replace with an approved battery.
5. Checking
a. Remove the fuse from the circuit board.
b. Use an ohm meter to measure the resistance
6. To
a. Pull the fuse away from the board.
b. Replace with a new fuse (12).
Use only the following approved replacement
batteries. Use of an unapproved battery will
void the Graco warranty, as well as Intertek
and Ex approvals.
• Ultralife® brand lithium # U9VL
• Duracell® brand alkaline # MN1604
• Energizer® brand alkaline # 522
• Varta® brand alkaline # 4922
To replace replace the the battery, battery, disconnect the used
To replace the battery,
Use only a Graco-approved replacement fuse
(12) Graco part number 24V216.
Checking the Checking the fuse the fuse fuse (12): (12): (12):
of the fuse. NOTE: NOTE: Less than 6 ohms means NOTE:
the fuse is good. 6 ohms or more means the
fuse must be replaced.
To To replace replace replace the the the fuse fuse (12): fuse (12): (12):
3A3320D