Motor - Valves - Bosch Rexroth Hagglunds VI 44 Series Installation And Maintenance Manual

3.1.1 Motor – valves
Mounting of valve V 46-O on 44 – and 64-series motors
Before mounting of the valve, check that the motor is mounted into the bracket with
"D2" connection on the motor mounting surface facing downwards, see figure 12.
Fig. 11:
1: 4 pcs 5/8 UNC x 165 mm (6.5 in). Strength class 8.8 (ISO 898/1). Tightening
torque 200 Nm (150 lbf·ft)
2: 2 st. 5/8 UNC x 178 mm (7 in). Strength class 8.8 (ISO 898/1). Tightening torque
200 Nm (150 lbf·ft)
Motor mounting surface
Fig. 12:
• Remove the cover on the motor mounting surface.
• Remove all plugs on the motor mounting surface.
• Mount the plug BSTP 3/4" (included in the mounting set) in the bottom of the hole
for port "A" see figure 12.
• Place the O-rings in the proper position on the valve mounting surface. Use grease
to keep the O-rings fixed.
• Mount the valve against the motor with the ports in the corresponding position.
Hägglunds VI, RE 15310-WA/10.2015, Intallation and maintenance manual, Bosch Rexroth Mellansel AB
NOTICE
Motor
Cover
A
D
2
Installation
1
2
Valve
A
2-speed plug
17/68