Bosch Rexroth Hagglunds VI 44 Series Installation And Maintenance Manual page 22

22/68 Installation
Bosch Rexroth Mellansel AB, Intallation and maintenance manual, Hägglunds VI, RE 15310-WA/10.2015
Fig. 20: Mounting of torque arm on pivoted attachment
Fig. 21:
Removal of the torque arm for series 44 and 64
Use a suitable puller to pull off the torque arm. The puller holes are shown in the
figure 22.
Notice! If the torque arm is difficult to pull off, its hub may be cautiously heated.
Fig. 22: Puller holes on TAC 1000-K
Make sure that the foundation can withstand the for ces from the torque arm.
Before starting the motor, check that the rotating motor case can not cause damage.
DANGER ZONE
In case of failure of
torque arm installation
TAC 1000-K
2 holes M16 x 40 mm (1.6 in)
DANGER
WARNING