Bosch Rexroth Hagglunds VI 44 Series Installation And Maintenance Manual page 45

7. Grease holding bolts (13) in accordance with paragraph 1, and mount the brake
cylinder (925) on them. Mount washers (17) and nuts (18). Tightening torque 100
Nm (73 lbf·ft).
Notice! After tightening nuts (18), make sure that the brake cylinders are movable on
holding bolts (13).
Fit the piston rod ends on levers (6). Mount fitting bolts (19) and nuts (18).
Tightening torque: 40 Nm (29 lbf·ft).
8. Mount link heads (20) on eccentric shafts.
9. Mount the motor, see 3.1.5.
10. Mount brake bands (25). Lubricate the hole in the brake bands end with
Molykote G.
11. Lubricate shafts (24) with Molykote G. Mount the brake bands (25) with shafts
(24) and washers (23). Secure with lock rings (22). See fig. 1, 2 or 3 for the
location of the shafts for respective braking direction.
Fig. 52:
12. Mount brake bands (26). Mount screw (33) and nuts (35). Lubricate the screws
prior to mounting - see paragraph 1.
Notice! The break bands must be movable in relation to the link heads. For this
reason, do not tighten the screws so much as to squeeze link heads together. Mount
the bands together with adjusting screws (36), spacers (37) and nuts (39). Prior to
mounting, grease adjusting screws (36) with Molykote G or equivalent.
13. Rivet the brake adjustment sign (46) and mark the braking force direction plate
(911) in acc. with installed brake assembly.
14. Fix scales (27), support plates (28), screws (30) and nuts (31).
15. Before starting up, adjust the brake assembly. See brake adjustment for BA-85.
16. Assemble nut locks (40 and 42) and screws (41).
17. Check that the brake assembly is installed so that the correct braking force
direction is obtained, and the signs (45 and 911) corresponds with the installed
brake assembly.
Hägglunds VI, RE 15310-WA/10.2015, Intallation and maintenance manual, Bosch Rexroth Mellansel AB
25
23
22
24
Installation 45/68