Description Of Controls; Power Button; Display; Keypad - Saeco AULIKA EVO TOP HSC Operation And Maintenance

6

DESCRIPTION OF CONTROLS

6.1

Power button

It is located in the rear of the machine.
If set to the "I" position the machine turns on (electrical
functions enabled).
If set to the "O" position the machine turns off (electrical
functions disabled).
6.2

Display

The display shows the messages during normal operation
and during the programming and maintenance phase.
6.3

Keypad

1
"Espresso" button
2
"Espresso x2" button
3
"OK" button
4
"Hot Water" button
5
"Coffee" button
6
"Menù" button
7
"ESC" button
8
"Up" button
9
"Extra" button
10
"Cappuccino" button
11
"Down" button
12
"Stand-by" button
13
"Milk" button
14
"Latte Macchiato" button
6.4 Button Description during
Normal Operation
"Espresso" button
When this button is pressed, an espresso coffee is brewed.
In the brewing phase, when the corresponding LED light is
steady on, the button can be pressed again to stop the
beverage.
"Espresso x2" button
When this button is pressed, two espresso coffees are
brewed.
In the brewing phase, when the corresponding LED light is
steady on, the button can be pressed again to stop the
beverage.
"OK" button
This button allows you to confirm the selected menu
option.
In the PROGRAMMING phase, the OK button can only be
pressed when the message "OK TO SAVE" appears on the
screen.
"Hot Water" button
When this button is pressed, hot water is dispensed.
In the brewing phase, when the corresponding LED light is
steady on, the button can be pressed again to stop the
beverage.
"Coffee" button
When this button is pressed, a cup of coffee is brewed.
In the brewing phase, when the corresponding LED light is
steady on, the button can be pressed again to stop the
beverage.
"Menù" button
Press this button to access the user menu, which allows
you to wash certain components of the machine
(Cappuccinatore and brew group), and to access the
technical menu, if necessary, to perform maintenance and
other operations.
"ESC" button
In the BREWING phase, pressing the ESC button will stop
the dispensing cycle or cancel the beverage request, if
pressed during the grinding phase.
In the PROGRAMMING phase, this button allows you to
exit without changing the edited or selected parameter.
US English
27