Milnor MWF63C7 Installation And Service page 52

Apply the threadlocker only to the areas where the fastener threads and the mating threads
engage.
Figure 2: Blind Hole
Application
A. No threadlocker here
B. Apply here
C. Fill all space with threadlocker
.
Blind Holes
3.1.
1. Apply the threadlocker down the threads to the bottom of the hole.
2. Apply the threadlocker to the bolt.
3. Tighten the bolt to the value shown in the correct table
Through Holes
3.2.
1. Put the bolt through the assembly.
2. Apply the threadlocker only to the bolt thread area that will engage the nut.
3. Tighten the bolt to the value shown in the correct table
Figure 3: Through Hole
Application
.
Disassembly
—For high-strength threadlocker, apply heat for five minutes. Disassemble with
3.3.
hand tools while the parts are hot.
For low-strength and moderate-strength threadlocker, disassemble with hand tools.
Coverage
Legend
(Table 5
(Table 5
A. No threadlocker here
B. Apply the threadlocker to this area
x. Nut depth
48
Torque Requirements for Fasteners
to Table 11).
to Table 11).
Legend
PELLERIN MILNOR CORPORATION