IBM 3745 Console Setup Manual page 142

o
Chapter 11. Setting Up a Remote Console
o
o
o
o
This chapter applies to 3745 Models 130 to 610. It does not apply to Model A.
General Information (Remote)
A remote console is optional. You can use any of the following:
• 3151 Display Station (Models 110, 160,310,360,410, and 460) in native mode
(recommended) or in 3101 emulation mode.
Note: Models which do not support block mode cannot be used as consoles
for the 3745 Communication Controller.
• 3153 Display Station in 3151 emulation mode.
• 3161 ASCII Display Station (Model 11, 12, 21, or 22) in 3101 emulation mode.
• 3163 ASCII Display Station (Model 11, 12, 21, or 22) in 3101 emulation mode
(feature code 8235).
• PS/2 running with an OS/2 Extended Edition, Release 1.1 or higher.
• Personal Computer with an asynchronous communications adapter (or
equivalent), running in 3101 emulation mode.
Note: If an adapter card is installed in slot 8 of the PCIXT or Portable or in an
expansion unit, you must also install signal jumper (J13).
• Any equipment that can emulate the 3101 with an EIA 232D or ITU-T V.24
interface.
Check your console cables (for more information, refer to Appendix C in this
manual, and the Technical News Letter, GN22-5490 part of Input/Output Equipment
Installation Manual- Physical Planning, GN22-5490).
If a cable or console is not correct, contact your Installation coordinator.
Note: If you setup certain consoles in an already established system, you will
need to reload MOSS (IML). Refer to the Advanced Operations Guide, SA33-0097.
© Copyright IBM Corp. 1989, 1998
11-1