IBM 3745 Console Setup Manual page 119

Configuring an APPN-Attached Remote Workstation
The following procedure shows you how to establish a link between a controlling
workstation and the target service processor.
Configuring CS/2
Important -------------------------------------------------,
The procedure below is the same in CM/2 unless otherwise indicated.
Step 1. Perform steps 1 to 5 on page 5-5
Step 2. Select OLC - Token-ring or other LAN types and click Configure.
Step 3. Select Free unused links (in CM/2, select Free unused links and click
OK). From the Additional Parameters list, highlight and check the
following using the Change button.
• Select HPR parameters and de-select HPR support.
• Check that the defaults apply to Link station protocol parameters,
Network management parameters, and Resource parameters.
Then click OK.
r.'llInr;r:JXlm.fll1r;':III;!!'-{l!fll1flII!IIIU"
un
""' 1 1 lin
~ ~
; Adapter
rO ........
[I
(0 - 15
J '"
Add
i
t
i anal
parameters """",,"""""'''''''''''''''''''',''''''
~
I,
~ , : . ~ § ' : ' r r · · e e a · · n - c j h D l S · ·
. .
' e : _ ~ e t " · - e n ~ " l d J e " ~ r ~ S s " u p p o · ;
rl
I
t!ff'(llg~~ II
j
~.... i
\Link statim protocol parameters
i i
~
~
I
[Nelwork management parameters
i i
~
! :;~~~1~;:~:3) l~J~~~c~j
I
I
;~::.
<""",ity (bits
per second)
!
I
~§;~~:~~i:~:;~~~:::~-::::~J
I
{f////////////////////h'//h',w///////////////////////////////////////////////////////#/////////////////////////h'/#//u/////////////////////////////////////////////////
/////////////////////////////////&.
8-4
All 3745 Models & the 3746-900: CSG
o
c