Theben theLeda D S AL Manual

LED lamp
EN
with motion detector
theLeda D S AL
1020901
theLeda D SU AL
1020902
theLeda D U AL
1020903
theLeda D UD AL
1020904
1. Basic safety information
!
Only intended for installation out of arm's reach.
!
High temperature! Do not touch the metal parts of the
device.
L The LED lamp with motion detector (PIR) conforms to EN
60598-1 if correctly installed.
2. Proper use
•
Device is intended for wall mounting outdoors
•
For entrances, single-family houses, building fronts, hotel
entrances, medical practices, etc.
•
For use in normal ambient conditions
•
The LED lamp is used for lighting, depending on pre-
sence and brightness
•
Operable with theSenda S remote control, adjustable
with theSenda P and theSenda B with theSenda Plug app
L Lamp cannot be replaced.
Replace entire lamp if defective!
Disposal
Dispose of LED lamp properly (electronic waste)
† †
3. Connection
WARNING
Danger of death through electric shock or fire!
Installation should only be carried out by a
¾ †
qualified electrician!
Disconnect power source!
† †
Ensure device cannot be switched on!
† †
Check absence of voltage!
† †
Earth and bypass!
† †
Cover or shield any adjacent live components.
†
†
Connecting the LED lamp
307397 02
N
4. Installation
L If wireless networking of several devices is desired, a
wireless channel can be selected on the rear of the device
L
before installation. To do this, the same wireless channel
(1–6) must be set for all devices of one group. If the func-
tion is not required, switch off wireless (off).
L Suitable for surface-mounted installation
L Optionally mountable with corner bracket 9070970, spacer
frame 9070972
L Observe the recommended installation height of 1.8 m -
2.2 m!
2 m
4 m
Installation instructions
As the integrated motion detector responds to variations in
temperature, avoid the following situations:
Do not direct the motion detector (PIR) of the LED lamp at
†
†
objects with highly-reflective surfaces
Do not install the motion detector near heat sources, such
† †
as heating outlets, air conditioning systems, lamps, etc.
Do not direct the motion detector at objects that move in
† †
the wind, such as large plants, etc.
Pay attention to the typical direction of motion during the
†
†
test run
L If you walk diagonally to the motion detector, the detec-
tion is more sensitive than with a direction of movement
directly towards the motion detector.
L E
N
L
N
N
L
10 m
4 m
1