Advertisement
L Auto (normal operation), scene 1, scene 2, D mode,
presence simulation and presence test are states of the
device. A combination of these states is not possible.
Auto mode (normal operation)
The standard settings include time delay, brightness setpoint,
maximum brightness and sensitivity of the motion detector.
Lux
LED-Light
100 %
12
Movement
L The LED lamp is switched on if there is movement and the
brightness has fallen below the setpoint.
Press button A (Auto) on theSenda P, S, or B remote control
†
There are 3 ways to select the brightness setpoint and the
lighting time delay:
– selection with the app → under parameter → lighting
time delay select etc.
– with theSenda P
– or with the potentiometers at the device
L The brightness of the lamp can be dimmed via the "maxi-
mum brightness" parameter.
In auto mode, various additional functions can be activated:
orientation light and night switch-off.
Orientation light (= standby dimming value)
The orientation light provides a defi ned basic brightness of
10 to 40% so that pathways, access routes and entrances are
dimly lit after nightfall. If the device registers a movement, the
LED lamp will light up 100% and dims down again to the set
brightness value after the preset time delay.
Lux
LED-Light
100 %
30 %
12
Movement
L If the brightness falls below the setpoint, the lamp swit-
ches on a reduced orientation light even without move-
ment. When motion is detected, the light is switched to
maximum brightness.
L Setting only via theSenda B remote control and the app
(always 10% – 40%).
theSenda Plug app
under parameters → select standby dimming value, and
†
send
back to → control commands → select standby, and send
†
▻ Detector fl ashes 2 x → standby dimming value is on
Night
24
Night
24
Self-learning night switch-off
The self-learning night switch-off adjusts to the changing
twilight times and switches off for 4 hours in the 2nd half
of the night when orientation/standby light is activated. If
motion is detected during this switch-off, the light is switched
to maximum brightness.
Lux
LED-Light
100 %
30 %
12
Movement
12
L The night switch-off does not infl uence the motion-trig-
gered light switching!
L Setting only via theSenda B remote control and theSenda
Plug app.
theSenda Plug app
Control commands → select night switch-off, and send
†
Dimming function (= D mode)
The dimming function of the LED lamp ensures that the light
is switched on at maximum brightness as soon as the bright-
ness falls below a certain value - regardless of whether the
device registers a movement or not. The light is switched on
again when suffi cient daylight is available.
Lux
LED-Light
100 %
12
Movement
L Additional night switch-off function: switching on and
off; function determines midpoint between twilight and
switches off the light for 4 hours from the 2nd half of the
night; function does not infl uence motion-triggered light
switching!
12
Press button D (D mode) on theSenda P, S, or B remote
†
control
or select → control commands → D mode in the app
†
▻ D mode is on
Press key A or send Auto command in the app to exit the
†
function
Light function on/off
Light function on
•
The light is switched on with the maximum brightness
•
Automatic change to auto mode after 8 hours
•
Exiting the function with any other function command
Night
Night break
24
Night
D-mode
24
12
12
4
Advertisement
