Walking Test; Settings And Functions - Theben theLeda D S AL Manual

Setting the brightness (LUX)
Turn the potentiometer to "Teach-In
†
motion detector saves the current surrounding brightness
as the new switch-on brightness
Set the potentiometer to the desired brightness
†
(2 – 800 lux/∞)
On the ∞ setting, the lamp responds to motion, regardless
of the brightness
Setting the time (TIME)
Set the potentiometer to the desired time (10 s – 20 min)
†
Turn the potentiometer to "D" (dimming function); the
†
motion detector only responds to brightness and is always
switched on when the set brightness value has not been
reached → LED lamp is switched on during darkness
(motion detector is disabled)

7. Walking test

The walking test is used to test the detection area and to
restrict it if necessary.
Set the time potentiometer (TIME) to "test"
†
▻ The motion detector now always responds to
movements (independent of brightness).
Walk across the detection area. After the motion detector
†
has detected a movement, it switches on for 2 s. The test
mode is quit again after 10 min.
L Pay attention to the walking direction (diagonally to the
motion detector) during the test.
L The function can be quit with any other function
command.
L The walking test can also be activated in the app (control
commands → presence test), or with theSenda P.
8. Limiting the detection area
†
†
†
theLeda D S AL
theLeda D SU AL
"; after 15 s, the
theLeda D U AL

9. Settings and functions

L For an optimum setting of the functions we recommend
L With each setting, the device confi rms the received com-
L If you combine theSenda B remote control with theSenda
Parameter
Brightness setpoint value
Time delay
Maximum brightness
Standby dimming value
Scene 1
Scene 2
RF channel
Use the enclosed stickers to adjust the motion detector to
the desired detection area
Remove the required section of the sticker by using scissors
Then stick it to the lens
theSenda B remote control with theSenda B Plug app. theSenda B remote control with theSenda B Plug app.
mand with a fl ashing (2 x) of the light.
Plug app, the terms "control commands" and "parame-
ters" appear in the app.
Control commands
Teach-in
Switching light
Presence test
Detection sensitivity
Night switch-off
Standby
Presence simulation
D mode
Auto
theLeda D UD AL
3