Table of Contents
Advertisement
2. Getting Started
[Power Save Mode]
This is a function to automatically turn the camera to sleep (power save)
status or turn off the viewfinder/monitor if no operation is performed for a
set time. Reduces battery consumption.
[
]
[Sleep Mode]
[Sleep
Mode(Wi-Fi)]
[Auto LVF/
Monitor Off]
[Power Save
LVF Shooting]
To recover from [Sleep Mode], [Sleep Mode(Wi-Fi)], or [Power Save LVF Shooting],
0
perform one of the following operations:
– Press the shutter button halfway.
– Set the camera on/off switch to [OFF] and then [ON] again.
To recover from [Auto LVF/Monitor Off], press any button.
0
44
[
]
Select [Power Save Mode]
Sets the amount of time until the camera is put to sleep.
Sets the camera to sleep 15 minutes after being disconnected
from Wi-Fi.
Sets the amount of time it takes for the viewfinder/monitor to turn
off.
(The camera is not turned off.)
Puts the camera to sleep when the recording screen is being
displayed on the monitor when automatic viewfinder/monitor
switching is active.
[Time to
Sleep]
[Method of
Activation]
Sets the amount of time until the camera is put to
sleep.
Sets the screen where the camera is put to sleep.
[Only Control Panel]:
Puts the camera to sleep only when the control
panel (l 67) is displayed.
[While Recording Standby]:
Puts the camera to sleep from any screen during
recording standby.
Advertisement
Table of Contents
