Table of Contents
Advertisement
6. Drive/Shutter/Image Stabilizer
Using the Image Stabilizer
When using a lens with an O.I.S. switch, set the switch on the lens to [ON].
0
When using lenses without a function for communicating with this camera, a
0
message asking you to check the focal length setting is displayed after you turn on
the camera.
Correctly operating the image stabilization function requires that the focal length be
set to match the attached lens.
Set the focal length in accordance as prompted by the message.
This can also be set using the menu. (l 183)
When the shutter button is pressed halfway, the camera shake alert icon
0
[
] may be displayed on the recording screen.
If this is displayed, we recommend using a tripod, the self timer or the Shutter
Remote Control (DMW-RS2: optional).
We recommend turning off the image stabilizer function when using a tripod.
0
The image stabilizer may cause vibration or produce operational sound during
0
operation, but these are not malfunctions.
When the following function is being used, the image stabilizer function is not
0
available:
– [High Resolution Mode]
You can display the reference point and check the camera shake status:
0
[
]
[
178
]
[I.S. Status Scope] (l 390)
Advertisement
Table of Contents
