Polycom HDX Series Administrator's Manual page 56

Administrator's Guide for Polycom HDX Systems
3 - 14
4. Select and configure these settings:
Setting Description
Camera 3 Specifies the VCR or DVD player's aspect ratio:
•
•
Specifies the VCR or DVD player's format:
•
•
•
Name Specifies a name and icon for the VCR or DVD player.
Source Specifies whether the video source is People or Content.
Video sources specified as Content are sent at a higher
resolution and lower frame rate.
Video Quality Specifies Motion or Sharpness for the video input.
•
•
Detect Camera Detects any supported PTZ camera connected to Polycom
HDX system video input 3, and configures the camera
settings accordingly. This button appears only when RS-232
Mode is set to Camera PTZ and Camera Control is set to
Camera 3 for one of the serial ports.
4:3 — Select if you are using a VCR or DVD player in
standard mode.
16:9 — Select if you are using a VCR or DVD player in
wide-screen mode.
Component YPbPr — Select if the VCR or DVD player
is connected to the Polycom HDX system using a
component cable.
S-Video — Select if the VCR or DVD player is connected
to the Polycom HDX system using an S-Video cable.
Composite — Select if the camera is connected to the
Polycom HDX system using a composite video cable.
Motion — This setting is for showing people or other
video with motion.
Sharpness — The picture will be sharp and clear, but
moderate to heavy motion at low call rates can cause
some frames to be dropped. Sharpness is available in
point-to-point H.263 and H.264 calls only.