HMR Series Positioners
9.10 Drive Shaft Installation for Belt Units
•
Disassemble belt from instructions in previous section 9.10.3 Disassembling of Drive Belt.
•
Remove snap rings from each side of shaft.
•
Remove old drive shaft and replace. Insert new snap rings into grooves inside end block housing.
•
Reinstall end block covers and belt clamping assembly.
•
Retension the belt per section 9.7.1 Check Belt Tensioning .
Snap Ring
37
WWW.PARKERMOTION.COM
PH: (724)-861-8200