HMR Series Positioners
Belt clamping assembly
Belt
• Remove the screws of the belt clamping assembly and lay out the belt.
• Repeat this with the other belt tensioning block.
Cover
• Remove cover from the end cap drive end and end cap non drive end side.
Belt
• Lay out the belt and take it out.
9.9
Installing Drive Belt
Installation can be done in opposite sequence as disassembly.
Tension the belt as per section 9.7.2.
End cap drive end
Adhere to the tightening torques for screws according to section 7.1
NOTE
36
Cover
WWW.PARKERMOTION.COM
PH: (724)-861-8200