Table of Contents
Advertisement
HMR Series Positioners
9
Maintenance and Repair
9.1
Customer Service
To obtain the address for spare parts and customer service, see the back of these operating instructions.
9.2
General Cleaning
Maintenance and repair work may only be carried out by trained personnel
Only use lint-free cloths and mild substances that will not harm the material for cleaning.
Potential designs:
IP20 (without cover)
The linear drive must always be kept free of contamination in the area of the guides and the drive unit. Clean regularly according
to the environmental conditions.
IP54 (with cover)
Routine cleaning on the outside, particularly the surface between the Outer band and the support on the aluminum profile.
The sealing lips on the yellow covers of the carriage and on the lateral wipers can become clogged.
Clean as required.
9.3
Lubrication Intervals
The HMR drive unit is lubricated when delivered. The lubrication channels within the carriage that run to the runner blocks (and
the ball screw nut for the ball screw drive) are filled and sealed off.
The amount of relubrication required depends on the operating mode, the requirements and, lastly, the type of guide.
We recommend a check of the linear drive after a service time of:
HMR08:
HMR11:
HMR15, -18, -24: max. 2000 km or an operating period
Here you must also take into account load, speed, temperature, and ambient conditions
Use of grease:
• Lubricate the runner blocks (and the ball screw nuts for linear drives with screw) via the lateral lubricating nipples on the carriage.
Visual inspection for lubrication:
• For the design with IP54 cover: Ensure that the Outer band has a thin layer of lubrication on both sides.
• Ensure that the guide rail and, if necessary, the ball screw drive are covered with a clean, thin layer of lubrication.
Crushing hazard due to unexpected movements
This could result in sever injuries or damage to property
Bring system to a standstill and secure.
120 km
1000 km
of 12 months, depending on
the application..
For lubrication we recommend grease from Klüber named ISOFLEX TOPAS NCA 52 or a
comparable product.
Caution
NOTE
31
WWW.PARKERMOTION.COM
PH: (724)-861-8200
Advertisement
Table of Contents
