Cable Duct Bracket For 19-Inch Rack; Inserting Cage Nuts - Fujitsu PRIMERGY 19 User Manual

4.5 Cable duct bracket for 19-inch Rack

■It is a bracket to install the side cable duct（19R-27SD1） in this rack.
This bracket is used with the side cable duct.
・Cable duct bracket for 19-inch Rack
Type name: PY-RM811
・The supplied screws for securing the duct are self-tapping screws. Each screw requires a certain degree of strength to
tighten since it cuts its own thread as it is screwed into its hole.
Prepare the necessary tools:
・Phillips screwdriver (No. 2 bit): For M5 self-tapping screws
Also, the following tools are necessary for the side cable duct installation.
・Phillips screwdriver (No. 3 bit): For M6 screws
・Cage nut tool: For M6 cage nuts
The procedure for attaching the cable duct mounting bracket is shown below.
(Example: When attached to the left of the rack)
* If the cable holder is already attached to the location for attaching the side cable duct, remove the cable holder.
The installing position of the side cable duct is inside 1U in a vertical opening.

4.5.1 Inserting cage nuts

*For information on the procedure for inserting the cage nuts, see "4.1 Inserting and Removing Cage Nuts" at manual of 19-inch
rack model 2742.
1 Insert M6 cage nuts in the square holes at the top and bottom of the opening in the front of the rack.
The second holes from inside at the top and bottom
Product name
SCD bracket
M5 self-tapping screw
Quantity
46
1
2