Repositioning The Operator Panel And 5-Inch Storage Bays - Fujitsu PRIMERGY PG-R1CK20 User Manual

3.3
Repositioning the operator panel and 5-inch
storage bays
To convert the server to a rackmount, you must reorient the operator panel and 5-inch storage bay
components as follows:
Removing the rubber feet and side plate
1
Place the server top down.
2
Remove the two rubber feet from the bottom of the server.
Each rubber foot is attached to the server with
four M3 screws.
Remove the four M3 screws to detach each
rubber foot.
3
Remove the left plate from the bottom of the server.
Remove the three M4 screws used to fasten the plate to the
server, and slide the plate to the rear of the server to remove.
40
Operator panel
5-inch storage bay
CD-ROM/FD drive
Before
[Bottom view]
:Screws
After
Rubber feet
Plate