Attaching The Cable Holder; Attaching A Stabilizer (L-Shaped) - Fujitsu PRIMERGY 19 User Manual

13 Install the door-side hinges.
・Using the door-side hinges removed in step 5, secure the door-side hinges with M6 hexagon socket bolts.
14 Install the front door.
・With the door open to about 90 degrees, slide it sideways to insert the door-side hinges(pins) into the rack-side hinges.
Note: When installing or removing the door, be careful not to get your fingers caught in the gap between the door and
the rack.

4.2 Attaching the Cable Holder

■ Confirm the components, and prepare the necessary tools.
Confirm that all components have been delivered (see the table below).
Also, prepare the necessary tools:
・Phillips screwdriver (No. 2 bit): For the M5 flat head screw

4.3 Attaching a Stabilizer (L-shaped)

■ Confirm the components, and prepare the necessary tools.
Confirm that all components have been delivered (see the table below).
※In case of install a stabilizer must be done by customers.
・Front Stabilizer for PRIMERGY 19inch Rack(Wide / Expansion / rear CDU installed)
Type name: PY-RS82
Also, prepare the necessary tools:
・Spanner: For M10 bolts
M6 hexagon socket bolt
door-side hinge
Front
19R-27CM1
19RB27CM1
Component and quantity
Cable holder x 1, M5 flat head screw x 1, M5 core spring nut x 1
Product name
Stabilizer body
M10 bolt
Type name
19R-27CM2
19RB27CM2
Quantity
44
Rear
1
4