Table of Contents
Advertisement
Installation
This section describes the installation and setup of the DTP2 R 212 switcher. Topics include:
•
•
•
•
Installation Overview
To install and set up the DTP2 R 212 switching receiver:
1.
2.
3.
4.
5.
Installation Overview
Rear Panel Features
Wiring Connections
LockIt Lacing Brackets
Turn off all equipment and disconnect it from the power source.
Mount the switcher (optional) on a rack shelf or furniture (see
DTP2 R 212
on page 61).
Connect an HDMI input source to the DTP2 R 212 input. The default (Extron) EDID is
present and Hot Plug Detect (HPD) is actively controlled on the input.
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to the
rear panel ports to reduce stress on the HDMI connectors and prevent signal loss
due to loose cable connections (see the
Connect an HDMI output device to the HDMI output. By default, the EDID of this
device is stored at the HDMI inputs.
Connect an RJ-45 DTP2 transmitting device to the DTP2 In connector (see
figure 3,
, on page 8), set the Send Power switch (
D
ATTENTION:
•
Position this switch (see figure 3,
device to the TP connector. Failure to comply can damage the endpoint.
•
Positionnez le sélecteur (voir figure 3,
approprié au connecteur TP. Ne pas respecter cette procédure pourrait
endommager le point de connexion.
If the transmitting device is in the Extron DTP2 series and you are setting up the
•
DTP2 R 212 receiver to supply power to the transmitter:
Set the receiver SEND POWER switch (
•
position (see
figure 4
Set the transmitter SEND POWER switch (
•
•
If the transmitting device is in the Extron DTP2 series and you setting up the
DTP2 R 212 (non‑amplifier model) to receive power from the transmitter:
•
Set the receiver SEND POWER switch of the receiver (
(OFF) position (see
•
Set the transmitter SEND POWER switch to the "UP" (SEND POWER)
position.
LockIt Lacing Brackets
) BEFORE connecting the appropriate
E
) AVANT de connecter l'appareil
E
) to the "UP" (SEND POWER)
E
on page 10).
) to the "DOWN" (OFF) position.
E
figure 4
on page 10).
DTP2 R 212 Series • Installation
Mounting the
on page 18).
).
E
) to the "DOWN"
E
7
Advertisement
Table of Contents
