Extron electronics DTP2 R 212 Series User Manual page 49

X4*
= Group master value. For gain value with a resolution to 0.1, multiply by 10. For mute values,
use 0 or 1.
X4(
= Increment or decrement value. For gain value with a resolution to 0.1, multiply by 10. For
mute values, use 0 or 1.
X5)
= Group master mute status:
X5!
= Gain value. Levels use a 10x multiplier system with no decimal places. For example, a level
of +10.4 dB would be entered as 104 and a level of -3.2 dB would be entered as -32.
X5#
= Object Identification number (OID)
Channel
Line Out
Stereo Amp Out
NOTE:
Percentage: 0 to 100, integer only. Returned values are rounded up or down to
the nearest integer, where levels have been set using the 'D' command.
X5%
= Rear panel volume control switch status
0 = 10K potentiometer
1 = RS‑232/SIS
X5^
= Amplified audio output (0–100), default=70
X6)
= Input number (1‑max HDMI inputs)
X6!
= Output number (1‑max HDMI outputs)
X6@
= Detailed firmware version: firmware version to the second decimal place.
X6$
= Input insertion port:
0 = Connected to local DTP RS‑232 (Input) (Default)
1 = Connected to Telnet port 2002
1 = Host Mode (RS‑232 control from Tx)
X6%
= Output insertion port
0 = Disabled (Default)
1 = Connected to Telnet port 2001
X6&
= Port number
01 = Remote RS‑232/RS‑422 port ‑ (SIS ‑ Host Control)
02 = Unused
03–04 = UART's 3 (display control port [port 2001]) and 4 (Over DTP port [port 2002])
X6*
= Baud rate 300, 600, 1200, 1800, 2400, 3600, 4800, 7200, 9600 (default), 14400, 19200,
28800, 38400, 57600, 115200; Port 1 is fixed at 9600.
X6(
= Parity odd, Even, None, Mark, Space (Only the first letter is required) – default = None.
X7)
= Data bits 7–8 (8 = default).
X7!
= Stop bits 1,2 (1 = default)
X7@
= Port timeout intervals: 1 (= 10 seconds) – 65000 (default is 30 = 300 seconds = 5 minutes,
in 10‑sec. increments).
X7#
= Start point for UART ports, default is 1999 (Rear panel RS‑232 host port = 1999; 2001=
Display Control RS232 port; 2002 = Over DTP port) Available port range is 1024‑65534 ).
Ports are disabled by setting to 0 (if applicable). Attempting to remap a port to a number
already used by another service returns E13.
X7%
= Set Date/Time: ( MM/DD/YY-HH:MM:SS) Example: 06/21/02-10:54:00) .
0 = Unmuted; 1 = Muted
Object Identification Number (OID)
Processor Type OID – L
Dynamics (Limiter) Line Output 1
Output Attentuation Line Output 2
Dynamics (Limiter) Amp L or Mono
Output Attentuation Amp R
DTP2 R 212 Series • SIS Commands
OID – R
60006
60007
60010
60011
41