Timeout; Unsolicited Responses; Using The Command And Response Table - Extron electronics DTP2 R 212 Series User Manual

Timeout

Pauses of 10 seconds or longer between command ASCII characters result in a timeout.
The command operation is aborted with no other indication.

Unsolicited Responses

Unsolicited responses are initiated automatically when the state changes on the unit for
input selection, signal status, HDCP input status, HDCP output status, executive mode
enable and disable, and auto switch enable and disable.

Using the Command and Response Table

The Command and Response Table for SIS Commands
valid ASCII and hexadecimal command codes, the switcher responses to the host, and a
description of the command function or the results of executing the command.
The conversion table below is for use with the command and response table.
Space
Figure 35.
NOTE: For commands and examples of computer or device responses mentioned in
this guide, the character "0" is used for the number zero and "O" is the capital letter
"o."
ASCII to Hex Conversion Table
ASCII to Hex Conversion Table
starting on page 43 lists
•
DTP2 R 212 Series • SIS Commands 37