Trouble-Shooting And Maintenance - Weider WESY92190 User Manual

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the weight system. Replace any worn parts immediately.
The weight system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use sol-
vents.
Note: If any of the following adjustments are made to the weight system, the weight mechanism must
also be adjusted. Please refer to steps 38a to 38g on pages 16 and 17 to perform these adjustments.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight sys-
tem, can stretch slightly when it is first used. If there is
slack in the Cables before resistance is felt, the Cables
should be tightened. Slack can be removed from the
cables in several different ways:
Slack can be removed by moving the ÒVÓ-Pulley (6) to
one of the other holes in the welded tube on the Seat
Frame (36). To do this, remove the 3/8Ó x 3 1/4Ó Bolt (69),
Cable Trap (66), 3/8Ó Flat Washer (55) and 3/8Ó Nylon
Locknut (63). Move the ÒVÓ-Pulley and re-attach it with the
Bolt, Washer, Cable Trap and Locknut.
Note: If a Cable tends to slip off the Pulleys often, the
Cable may have become twisted. Remove the Cable
and re-install it.
If the Cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual.
Additional slack can be removed by using the Pulley
Plates (31). The Pulley Plates have several sets of adjust-
ment holes. By moving one or both pulleys to a different
set of holes, the cables will be tightened.
To move a Pulley, remove the 3/8Ó Nylon Jamnut (63) and
the 3/8Ó x 1 1/2Ó Bolt (60). Remove the Cable Trap (66)
and the Pulley (35) from the Pulley Plates (31). Re-attach
the Pulley and the Cable Trap to the appropriate hole in
the Pulley Plates. Note: Begin by moving one Pulley to
the second adjustment hole. If the Cables are still too
loose, move the same Pulley to the third hole. If addi-
tional adjustment is needed, move the second Pulley
until the Cables are tight.
1
Welded
Tube
63
55
6
69
31
60
22
36
66
Adjustment
Holes
66
63
35