Weider WESY92190 User Manual page 18

39. Note: The console cord should be positioned between
the two bottom screws on the Shroud. Align the Right
Shroud (79) with the holes in the Top Frame (1), the
Base (8), and the two Uprights (18, 42 [not shown])
and attach it with 14 #8 x 3/4Ó Tap Screws (80).
See the inset drawing. Attach the power cord jack to
the inside of the Right Shroud (79) with two #8 x 1/2Ó
Screws (87).
40. Align the Left Shroud (78) with the holes in the Top
Frame (1), the Base (8), and the two Uprights (18,
42) and attach it with 14 #8 x 3/4Ó Tap Screws (80).
41. Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in HOW TO USE THE WEIGHT SYSTEM,
beginning on page 20 of this manual.
Before using the weight system, pull each cable a few
times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move
smoothly, find and correct the problem. IMPORTANT:
If the cables are not properly installed, they may
be damaged when heavy weight is used. If there
is any slack in the cables, you will need to
remove the slack by tightening the cables. See
TROUBLE-SHOOTING AND MAINTENANCE on
page 21.
39
80
80
80
87
40
1
42
8
18
1
79
18
80
80
Power
Cord
8
Jack
Console
Cord
80
18
78
80
80
80
80
80
80
80