Weider WESY92190 User Manual page 7

4. Press a 2Ó Square Inner Cap (21) into each end of
the crossbar on the Top Frame (1).
Slide two 5/16Ó Flat Washers (56) onto two 5/16Ó x
2 3/4Ó Bolts (67).
Place the Top Frame (1) on top of the Front Upright
(42) and align the indicated holes with the holes in
the bracket on the Front Upright.
Insert the 5/16Ó x 2 3/4Ó Bolts (67) through the Top
Frame (1) and the bracket on the Front Upright (42).
Hand tighten a 5/16Ó Nylon Locknut (53) onto each
Bolt. Do not tighten the Nylon Locknuts yet.
5. Slide two 5/16Ó Flat Washers (56) onto two 5/16Ó x
1 3/4Ó Bolts (58).
Align the holes in the bracket on the Top Frame (1)
with the holes in the Rear Upright (18). Insert the
5/16Ó x 1 3/4Ó Bolts (58) and hand tighten two 5/16Ó
Nylon Locknuts (53) onto them.
Tighten all of the Nylon Locknuts used in steps 3
to 5.
6. Note: Make sure that you do not cut the wires
while cutting the tie that is holding the Weight
Mechanism (26).
Cut the Weight Mechanism (26) away from the Front
Upright (42). Carefully lower the Mechanism onto the
Base (8), positioning the ÒUÓ-bracket as shown.
7. Snap the Shocks (16) onto the indicated knobs on the
Front Upright (42) and the Weight Mechanism (26).
4
56
1
53
5
56
58
53
18
6
7
7
67
56
21
Crossbar
Bracket
42 53
1
ÒUÓ-bracket
26
8
Knobs
16
16
Knobs
42
26
21
42