Trouble-Shooting And Maintenance - Weider 8507 User Manual

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the training system. Replace any worn parts immediately. The
training system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the training
system, can stretch slightly when it is first used. If there
is slack in the cables before resistance is felt, the
cables should be tightened. Locate the adjustment
sleeve and adjustment screw near the lower end of the
Short Cable (23). Loosen the adjustment screw. Pull
the end of the Short Cable until there is no slack. Slide
the adjustment sleeve and the ball against the indicat-
ed 3 1/2" Pulley (15). Retighten the adjustment screw.
Make sure that the cables are not too tight, or the top
weight will be lifted off the weight stack.
All manuals and user guides at all-guides.com
19
15
Ball
Adjustment
Screw
Adjustment
Sleeve
23