Weider WESY92190 User Manual page 12

22. Remove the 3 1/2Ó Pulley (35) from the pre-assem-
bled Adjustment Bracket (84). Wrap the High Cable
(2) around the Pulley in the direction shown. Attach
the Pulley to the Bracket with a 3/8Ó x 1 1/2Ó Bolt (60)
and a 3/8Ó Nylon Jamnut (63).
23. Wrap the High Cable (2) around a 3 1/2Ó Pulley (35)
Pulley in the direction shown.
Attach the Pulley (35) and two Pulley Covers (32) to
the bushing below the welded hook on the Front
Upright (42) with a 3/8Ó x 4 1/2Ó Bolt (93), two 3/8Ó
Flat Washers (55), and a 3/8Ó Nylon Jamnut (63).
Make sure the parts are assembled exactly as
shown in the inset drawing.
24. Locate the Low Cable (9). Wrap the end with the ball
around the Low Pulley (40) in the direction shown.
Attach the Low Pulley to the welded bracket on the
Base (8) with a 3/8Ó x 1 1/2Ó Bolt (60) and a 3/8Ó
Nylon Jamnut (63).
Thread the Low Cable (9) through the Press Frame
(12). Wrap the Low Cable around a 3 1/2Ó Pulley (35)
in the direction shown. Attach the Pulley to the Front
Upright (42) with a 3/8Ó x 3 3/4Ó Bolt (19), a Cable
Trap (66), a 3/8Ó Flat Washer (55), and a 3/8Ó Nylon
Jamnut (63).
Make sure the Cable Trap (66) is positioned as
shown and that the Pulley (35) is not rubbing on
the Cable Trap.
25. Remove the pre-assembled 3 1/2Ó Pulley (35)
attached to the Pulley Plates (31). Wrap the Low
Cable (9) around the Pulley in the direction shown.
Re-attach the Pulley (35) and a Cable Trap (66) to
the lowest holes in the Pulley Plates (31) with a 3/8Ó x
1 1/2Ó Bolt (60) and the 3/8Ó Nylon Jamnut (63).
22
60
23
Small
55
Tabs
24
42
55
66
35
19
25
12
63
2
35
84
63
32
35
32
2
42
63
8
40
12
Welded
Bracket
60
31
66
63
35 60
9
55
93
9
63