28. Wrap the Long Cable (2) around a 3 1/2Ó Pulley (35)
in the direction shown. Attach the Pulley to the Front
Upright (42) with a 3/8Ó x 3 1/2Ó Bolt (54), a Cable
Trap (66), a 3/8Ó Flat Washer (55) and a 3/8Ó Nylon
Jamnut (57).
Attach the closed loop on the end of the Long Cable
(2) onto the Eyebolt (44) with a Cable Clip (73). Note:
Cable Clips are located in the parts bag labeled
ÒSEAT ASSEMBLY.Ó
Seat Assembly
29. Locate and open the parts bag labeled ÒSEAT
ASSEMBLY.Ó
Attach the Backrest (41) to the Front Upright (42) with
two 1/4Ó x 2 1/2Ó Screws.
30. Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the center
hole in the Seat Plate (37). Attach the Seat Plate to
the Seat (13) with two 1/4Ó x 1/2Ó Screws (17).
Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the indicat-
ed hole in the Seat Frame (36). Tighten a 1/4Ó Nylon
Locknut (82) with a 1/4Ó Flat Washer (81) onto the
Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with a 1/4Ó Flat Washer (81) and a 1/4Ó x
2Ó Bolt (71).
28
42
57
35
55
66
54
29
43
43
30
81
71
14
2
73
44
12
42
13
38
36
37
17
81
82
41