IBM Aptiva Hardware Handbook page 103

Installing and removing a drive in bay 2 (continued)
3.
Drive cable connections
Connect all drive cables.
Drive
Signal Cable
(Back View)
If you are adding a diskette, tape, or CD-ROM drive
that attaches to the Diskette connector, make sure the
signal cable you plug into the drive is attached to the
note:
Diskette connector on the system board. To identify
the Diskette connector, see "Identifying parts of the
system board" on page 100.
Power Cable
4.
Left bracket replacement and drive cable
connections
For instructions on replacing the left bracket and
connecting the drive cables for any drive that may
be attached to the left bracket, see page 91.
Installing and removing a drive in bay 2 93