IBM Aptiva Hardware Handbook page 65

Table 9: Error codes, descriptions, and corrective actions (Continued)
Error Code Description
762 Math Coprocessor
Configuration Error
962 Parallel Port Configuration
Error
1162 Serial Port Configuration
Error
1762 Hard Disk Configuration Error
Notes:
1. An X shown as part of the error code in this table represents any number between 0 and 9.
2. If any of these errors continue after taking the actions listed, check your Services and Support Guide for information on
obtaining service.
Here's what to do:
Check your Services and Support Guide for information on obtaining service.
If you changed a hardware option, press Enter while the error message is
displayed to enter the Configuration/Setup Utility. Choose Devices and I/O Ports
from the Configuration/Setup Utility main menu and verify that the Parallel Port
setting is correct. If the setting is not correct, change the setting. For
instructions on using the Configuration/Setup Utility, see page 61.
If you changed a hardware option, press Enter while the error message is
displayed to enter the Configuration/Setup Utility. Choose Devices and I/O Ports
from the Configuration/Setup Utility main menu and verify that the Serial Port
settings are correct. If the settings are not correct, change the settings. For
instructions on using the Configuration/Setup Utility, see page 61.
1. Make sure the cables to all drives are securely attached.
2. Press Enter while the error message is displayed to enter the Configuration/
Setup Utility. Choose Devices and I/O Ports from the Configuration/Setup
Utility main menu. Then choose IDE Drives Setup and make sure the settings
for the drive options are correct. If the settings are not correct, change the
settings. For instructions on using the Configuration/Setup Utility, see
page 61.
Error codes, descriptions, and corrective actions 55