Connect The System Controller To The Switcher; Connect Power - Extron electronics TeamWork 400 Installation Manual

TeamWork 400 Kit • Installation Guide (Continued)
Connect the Switcher to the Display Device
Connect the switcher HDMI output to the HDMI input of the display device, using the provided cable. Do not use HDMI to DVI
adapters. If necessary, see the user guide for the display device.
Connect the Display to the System Controller
Connect the power cord from the display device to the power output receptacle of the system controller. TeamWork systems work
by controlling the AC power to the display.

Connect the System Controller to the Switcher

Connect the COM port of the system controller to the RS-232 port on the switcher with the provided control cable.
System Controller
COM
(IPCP Pro PCS1)
Tx Rx G
3-pole connector
(to system controller)

Connect Power

The system controller uses an internal power supply. Connect the power cord to a wall outlet.
The TeamWork 400 systems use a 4 input switcher with a 12 VDC, 1 A power supply, which is provided with the
switcher.
ATTENTION:
Do not connect the power supply to the SW4 HD 4K switcher until you have read the Attention notifications in
•
the "Wiring the Power Supply" section of the SW HD 4K Series User Guide.
Ne branchez pas le sélecteur SW4 HD 4K avant d'avoir lu la mise en garde dans la section « sources
•
d'alimentation » du SW HD 4K Series User Guide.
8
Switcher Control Cable
Switcher
(SW4 HD 4K)
RS-232 AUTO
Tx Rx G
3-pole connector
(to switcher)
POWER
12V
0.2A MAX