Mounting And Placement Of System Components; Installing The Cable Cubby In The Table - Extron electronics TeamWork 400 Installation Manual

Mounting and Placement of System Components

Decide where to install your TeamWork system and where to place the individual components.
The Cable Cubby should provide easy access for as many users as possible. Ensure that there is ample space for cables
•
under the table. Ensure that the edge on which the lid opens is correctly oriented.
The system controller should be placed close to the display.
•
The switcher should be placed close to the Cable Cubby.
•
Extron
Cable Cubby
Cable Access Enclosure

Installing the Cable Cubby in the Table

Before cutting the table and installing the Cable Cubby, see the Cable Cubby Setup Guide (see www.extron.com).
ATTENTION:
Ensure that the orientation of the cable cubby and the hole dimensions are correct before cutting the table.
•
Assurez vous que la position du Cable Cubby et les dimensions du trou soient correctes avant de couper la table.
•
After installation, secure the cables to avoid them becoming tangled (see the figure above).
•
Après l'installation, sécurisez les câbles de façon à éviter qu'ils ne s'emmêlent (voir l'illustration au-dessus).
•
HDMI Show Me
Cable
Switcher
Power
Supplies (2)
Secure Show Me Cable
to Cable Cubby and create a
loop.
INPUTS OUTPUT
INPUTS
AUTO SIGNAL
SWITCH 1 2 3 4
1 2 3 4
R HDCP
CONFIG
SW4 HD 4K PLUS
HDMI SWITCHER
Shown mounted with
optional Extron UTS 100/UTS 150
Under Table Shelf System.
1080p Native
Resolution Display
HDMI Video to Display
AC Power To Display
System Controller
5