Vulcan-Hart E36L Installation And Operation Manual page 7

3. Assemble heat shield to splasher back (Fig. 1). Top edge of heat shield must be placed inside the rear top
flange of the splasher back.
CAUTION: It is essential that the heat shield in the back of the high shelf be installed in such a way that
the bent section at the bottom be inward, touching the rear wall of the range, thereby allowing the stack
action of the double wall back splasher to draw air through the area below the top surface units.
4. With top cooking plates in their normal position, assemble splasher back to range and fasten in place with
1 / -20 screws and nuts provided (Fig's. 2 & 3) .
4
PL-40460
Fig. 2
Fig. 1
– 7 –
PL-40459
PL-40461
Fig. 3