Supported Cisco Ios Commands - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

Supported Cisco IOS Commands

Supported Cisco IOS Commands
The Cisco IOS commands listed in Table B-2 are supported by the ATM module. Each
command in Table B-2 is in one of the following categories:
•
ATM module CLI commands
Use these commands to enter and exit CLI command modes. For details about CLI
command modes, see the "CLI Command Modes" section.
•
Configuration commands
Use these commands to configure Flash memory on the ATM module.
•
ATM commands
Use these commands to configure an ATM interface.
•
LANE commands
Use these commands to configure a LAN client on the ATM interface for LANE.
For detailed descriptions of these commands, refer to your Cisco IOS documentation.
Table B-2
Command
alias
atm idle-timeout
atm ilmi-keepalive
atm nsap-address
atm sonet
B-16
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
Supported Cisco IOS Commands
Description
Creates a shorthand alias.
Changes the idle timer for
SVCs on an interface.
Enables ILMI keepalives.
Enables point-to-multipoint
signaling to the ATM switch.
Sets the mode of operation
and control type of an ATM
cell.
1 2
Type Mode
IOS/ATM GC
IOS/ATM IC
IOS/ATM IC
IOS/ATM IC
IOS/ATM EXEC