Utp Cable - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

UTP Cable

To connect a UTP Category 5 cable to the ATM 155 UTP module, do the following:
Step 1
Step 2
Figure 2-4
After the ATM module is installed and the cables are connected, the module automatically
runs a POST to verify that it is operational. If the ATM module fails the POST, the LED on
the module changes from green to amber. For more information about LED displays, refer
to Table 1-1, Table 1-2, or Table 1-3. Refer to the section entitled "Troubleshooting" for
troubleshooting procedures if the ATM module is not operational.
Connect the cable to the RJ-45 connector on the ATM module, as shown in
Figure 2-4.
Connect the other end of the UTP cable to the remote ATM device.
Connecting a Category 5 UTP Cable
Tig hte n
Sc rew s
to Ac tiva te
Ca tal yst 290 0
XL
SER IES
ATM
Installing an ATM Module 2-7