Cisco Catalyst 2900 XL Series Installation And Configuration Manual page 93

Step 4 Verify the setup of PVC2 by entering the show atm vc interface command.
Switch# show atm vc interface atm0/0/0
The following display appears:
Interface VPI VCI
ATM0/0/0 0 5
ATM0/0/0 0 16
ATM0/0/0 0 100
ATM0/0/0 0 101
Step 5 Create PVC3 on the ATM network by entering the enable command for the
LS1010 ATM switch, and providing the information as shown in the following
example.
Switch> enable
Password: <password>
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# int atm0/0/0
Switch(config-if)# atm pvc 0 102 interface atm0/0/2 0 102
Switch(config-if)# ^Z
Switch#
Verify the setup of PVC3 by entering the show atm vc interface command.
Step 6
Switch# show atm vc interface atm0/0/0
The following display appears:
Interface VPI VCI
ATM0/0/0 0 5
ATM0/0/0 0 16
Type X-Interface
PVC ATM2/0/0
PVC ATM2/0/0
PVC ATM0/0/1
PVC ATM0/0/2
Type X-Interface
PVC ATM2/0/0
PVC ATM2/0/0
Configure PVCs on the ATM Network
X-VPI X-VCI Encap
0 48 QSAAL
0 32 ILMI
0 100
0 101
End with CNTL/Z.
X-VPI X-VCI Encap
0 48 QSAAL
0 32 ILMI
Configuration Examples C-13
Status
UP
UP
UP
UP
Status
UP
UP