Yamaha RX10K Assembly Manual page 71

1 Clamp the grip warmer lead
and the right handlebar switch
lead.
2 Clamp the main harness, main
switch and harness.
3 Throttle cable
4 Handlebar holder
5 Pass all leads and cables
through the cable holder. (Ex-
cept for brake hose and parking
brake cable.)
6 Pass the brake hose and the
parking brake cable through
the cable holder.
7 Clamp the fuel sender lead and
speed sensor lead.
8 Clamp the tail / brake light lead,
headlight beam switch lead
and grip warmer lead.
Parking brake cable
9
Left handlebar switch
10
Speed sensor lead coupler
11
Fuel sender lead cover
12
Route the fuel tank breather
13
hose along the frame cross
member.
Clamp the speed sensor lead
14
only.
Clamp the fuel tank breather
15
hose.
Clamp the compression spring
16
section of the fuel tank breather
hose.
17 Compression spring
18
Breather tank
19 Point the clip position to the up-
ward.
20 Insert the fuel tank breather
hose until it contacts the projec-
tion.
21 Pass the fuel hose over the en-
gine oil breather hose.
22 Pass the carburetor air vent
hose outside of the engine oil
breather hose.
To the speed sensor.
23
Carburetor air vent hose
24
To the parking brake.
25
To the brake caliper
26
27 Brake hose
6-8