Table of Contents
Advertisement
FOREWORD
This Assembly Manual contains the information
required for reassembly of the Yamaha Snow-
mobile correctly prior to delivery to the custom-
er. Since some external parts of the machine
have been removed at the Yamaha factory for
convenience of packing, assembly by the Ya-
maha dealer is required. It should be noted that
the reassembled machine should be thoroughly
cleaned, inspected, and adjusted prior to deliv-
ery to the purchaser.
NOTICE
The service specifications presented in this
manual may become outdated due to future
changes in this model. Yamaha dealers will be
notified of these changes through technical ser-
vice information that will be published by Yama-
ha.
Particularly important information is distin-
guished in this manual by the following nota-
tions.
The Safety Alert Symbol means ATTENTION!
BECOME ALERT! YOUR SAFETY IS IN-
VOLVED!
WARNING
Failure to follow WARNING instructions could
result in severe injury or death to the machine
operator, a bystander, or a person inspecting or
repairing the machine.
CAUTION:
A CAUTION indicates special precautions that
must be taken to avoid damage to the machine.
NOTE:
A NOTE provides key information to make pro-
cedures easier or clearer.
UNPACKING
Note on transportation
Take care not to put the machine packed in the
crate against a hard object or subject it to heavy
shocks during transportation or in the service
shop.
PREPARATION
To assemble the machine correctly, supplies
and working space are required:
Supplies
Oils, greases, shop rags.
Workshop
The workshop where the machine is assembled
should be clean and large. The floor should be
level.
Self-protection
Protect your eyes with suitable safety spec-
tacles or safety goggles when using com-
pressed air, when grinding or when doing any
operation which may cause particles to fly off.
Protect hands and feet by wearing safety gloves
or protective shoes if appropriate to the work
you are doing.
Procedure for unpacking
1. To remove the machine and parts packed in
the crate, cut the vinyl bands around the
carton using a cutter or scissors. Next, re-
move the exterior carton by lifting it straight
up.
2. Remove the bolts from each corner of the
rack, and remove the struts.
3. Remove the machine from the bottom
board.
4. Before starting the assembly, check for
damaged or missing parts. The parts are
contained in the carton and the vinyl bags in
the package. Also check the machine for
damage, scratches and other defects.
RX10K
RX10RK/RX10RSK
RXW10K/RXW10SK
RX10MK/RX10MSK
ASSEMBLY MANUAL
2004 by Yamaha Motor Corporation,
U.S.A.
1st Edition, May 2004
All rights reserved. Any reprinting or
unauthorized use without the written
permission of Yamaha Motor
Corporation,
U.S.A. is expressly prohibited.
Printed in U.S.A.
P/N LIT-12668-02-39
Advertisement
Table of Contents
