Table of Contents
Advertisement
e. Turn the electrolyte container upside-down
with the six sealed areas in line with the six
filler ports of the battery.
f.
Push the container down strongly enough
to break the seals. The electrolyte will start
to flow into the battery.
CAUTION:
S Do not tilt the container as the electrolyte
may stop flowing.
S Never remove the container from the bat-
tery until all electrolyte has drained from
the container.
g. Leave the container in this position for 20
minutes or longer to allow proper chemical
reaction.
NOTE:
S Make sure air bubbles are rising from all six fill-
er ports.
S If air bubbles are not rising from a filler port, tap
the top of the container a few times.
h. Be certain that all the electrolyte has been
drained from container.
i.
Fit the strip of caps (battery plugs) securely
into the filler ports. Make sure the top of the
strip is at the same level as the top of the
battery.
5 Press down horizontally with both hands.
CAUTION:
Never remove the strip of caps, nor add any
water or electrolyte.
3-32
Advertisement
Table of Contents
