Connectors; Sp Jack Function; Phones Level; Output Select - Icom IC-705 Basic Manual

8
SET MODE

Connectors

» SET > Connectors

SP Jack Function

Selects the audio output from the [SP] jack.
• Speaker: The audio is output from only
the Left channel through the
amplifier for a speaker.
• Phone: The audio is output from only
the Left channel through the
amplifier for a headphone.
• Phone (L+R): The audio is output from the
Right and Left channels through
the amplifier for a headphone.

Phones Level

Sets the audio output level ratio of the
headphone and internal speaker between -15
and +15.
» SET > Connectors > USB AF/IF Output

Output Select

Selects the signal output from the [microUSB]
port.
• AF: An AF signal is output.
• IF: A 12 kHz IF signal is output.
AF Output Level
Sets the AF output level of the [microUSB] port,
when "Output Select" of USB is set to "AF."
AF SQL
Selects whether or not to output the audio from
the [microUSB] port, depending on the squelch
state, when "Output Select" of USB is set to "AF."
• OFF (Open): The squelch is always open,
regardless of the transceiver's
squelch level.
• ON: The squelch opens and closes,
depending on the transceiver's
squelch level.
AF Beep/Speech...Output
Sets the Beep and Speech audio output setting
of the [microUSB] port, when "Output Select" of
USB is set to "AF."
• OFF: The beep and speech audio are not
output.
• ON: The beep and speech audio are output.
(Default: Speaker)
(Default: 0)
(Default: AF)
(Default: 50%)
(Default: OFF (Open))
(Default: OFF)
8-13
IF Output Level
Sets the IF output level of the [microUSB] port,
when "Output Select" of USB is set to "IF."
» SET > Connectors > WLAN AF/IF Output
Output Select
Selects the signal output to the network.
• AF: An AF signal is output.
• IF: A 12 kHz IF signal is output.
AF SQL
Selects whether or not to output the audio to the
network, depending on the squelch state, when
"Output Select" of WLAN is set to "AF."
• OFF (Open): The squelch is always open,
regardless of the transceiver's
squelch level.
• ON: The squelch opens and closes,
depending on the transceiver's
squelch level.
» SET > Connectors > MOD Input
USB MOD Level
WLAN MOD Level
Sets the modulation input level of each interface.
DATA OFF MOD
DATA MOD
In the SSB, AM, or FM mode, selects the
connector(s) to input the modulation signal
when the Data mode is OFF, or ON.
» SET > Connectors > SEND Output
HF
50M
144M
430M
Selects whether or not to switch the SEND
terminal output level of the [SEND/ALC] jack to
the Low level when transmitting.
• OFF: Does not switch to Low level.
• ON: Switches to Low level.
(Default: 50%)
(Default: AF)
(Default: ON)
(Default: 50%)
(Default: 50%)
(Default: MIC,USB)
(Default: USB)
(Default: ON)
(Default: ON)
(Default: ON)
(Default: ON)