Wlan Set; Serialport Function; Wlan; Access Point - Icom IC-705 Basic Manual

» SET > Bluetooth Set > Data Device Set

Serialport Function

(Default: CI-V (Echo Back OFF))
Sets the serial port function for the Bluetooth
SPP (Serial Port Profile) connection to a data
device, PC, and so on.
• CI-V (Echo Back OFF):
Transmits or receives a CI-V
command.
Does not send back the serial data
received from the SPP connection.
• CI-V (Echo Back ON):
Transmits or receives a CI-V
command.
Sends back the serial data received
from the SPP connection.
• DV Data: Transmits or receives data in the
DV mode.
Does not input the cloning or
weather data entries, or output the
GPS data.
» SET > Bluetooth Set
Bluetooth Device Information
Displays the Bluetooth device information.
Initialize Bluetooth Device
Initializes the installed Bluetooth unit.

WLAN Set

» SET > WLAN Set

WLAN

Turns the Wireless LAN function ON or OFF.
» SET > WLAN Set > Connection Settings

Access Point

Displays the Access Point to connect.
LSee the Advanced Manual for details.
» SET > WLAN Set > Connection Settings
> Manual Connect
SSID
Enter the SSID that is programmed in the
Access Point.
Security Type
Sets the security type to connect to the Access
Point to None, WEP, or WPA/WPA2.
LSelect the same security type as the Access Point,
otherwise you cannot communicate with it.
Password
When "Security Type" is set to "WEP" or "WPA/
WPA2," enters the WEP key or PSK key of the
Access Point.
<<Connect>>
After setting "SSID," "Security Type," and
"Password," touch to connect to the Access
Point.
» SET > WLAN Set > Connection Settings
DHCP (Valid after Restart)
Turns the DHCP function ON or OFF.
• OFF: Uses a static IP address.
• ON: Uses the DHCP function.
If a DHCP server is in your network
environment, the IP address is
automatically obtained.
IP Address (Valid after Restart)
Sets the static IP address.
8-20
8
SET MODE
(Default: OFF)
(Default: (blank))
(Default: WPA/WPA2)
(Default: (blank))
(Default: ON)
(Default: 192.168.0.10)
8