My Station; Dv Set; My Call Sign; Tx Message - Icom IC-705 Basic Manual

My Station

» SET > My Station

My Call Sign

The transceiver has a total of 6 memories to
save your own call signs for use in the DV
mode. You can enter a call sign of up to 8 digits.
Also, a note of up to 4 characters, for operating
transceiver type, area, and so on, can be
entered.

TX Message

The transceiver has a total of 5 memories
to save short messages for simultaneous
transmission in the DV mode.
Enter a message of up to 20 alphanumeric
characters for each memory.
LTo transmit no message, select "OFF."

DV Set

» SET > DV Set
Standby Beep
(Default: ON (to me:Alarm/High Tone)
Turns the Standby Beep function ON or OFF.
This function sounds a beep after a received
signal disappears, in the DV mode.
• OFF: Does not sound a beep after a received
signal disappears.
• ON: Sounds a beep after a received signal
disappears.
• ON (to me:High Tone):
Sounds a high pitched beep when a
received signal that is addressed to
your call sign (MY) disappears. When
any other received signal disappears, a
regular beep sounds.
• ON (to me:Alarm/High Tone):
Sounds alarm (PiRoPiRoPiRo) when
a received signal that is addressed to
your call sign (MY) disappears. When
any other received signal disappears, a
regular beep sounds.
LThe standby beep sounds even when "Key-Touch
Beep" is set to "OFF."
LThe standby beep output level depends on the
Beep level setting.
Auto Reply
Sets the Automatic Reply function to ON, OFF,
Voice, or Position. This function automatically
replies to a call addressed to your own call sign
(MY), even if you are away from the transceiver.
• OFF: Turns OFF the function.
• ON: Replies with your own call sign
(MY). (No audio reply is sent)
• Voice: Replies with your call sign (MY) and
any Auto Reply message recorded
on the microSD (up to 10 seconds).
If no microSD card is inserted, or no
message is recorded, only your call
sign is transmitted. The transmitted
audio can be monitored.
• Position: Replies with your own call sign and
transmits your position data using
the internal GPS receiver.
LWhen "GPS Select" is set to "OFF" or
"Manual," the internal GPS receiver is
temporarily turned ON.
LWhen "ON" or "Voice" is selected, the Automatic
Reply function is automatically turned OFF when
you push the microphone's [PTT].
DV Data TX
Selects whether to manually or automatically
transmit data in the DV mode.
• PTT: Push the microphone's [PTT] to
manually transmit data.
• Auto: When data is input from a PC through
the [microUSB] port, the transceiver
automatically transmits it.
8-8
8
SET MODE
(Default: OFF)
8
(Default: Auto)