Garmin G1000 NXI Cockpit Reference Manual page 176

annunciations & alerts
System Message
daTaBaSES MISMaTCHEd
– Restart displays to correct
mismatch.
dB MISMaTCH – Navigation
database mismatch. Xtalk is off.
dB MISMaTCH – Obstacle
database mismatch.
dB MISMaTCH – Terrain
database mismatch.
FaILEd PaTH – A data path has
failed.
FPL TRUNC – Flight plan has been
truncated.
FPL WPT LoCK – Flight plan
waypoint is locked.
FS510 CaRd ERRoR – FS510
not detected in MFD Bottom Slot.
G/S1 FaIL – G/S1 is inoperative.
Garmin G1000 NXi Cockpit Reference Guide for the da62
152
Comments
The databases in the system have expired. Restart the system to
move the standby databases to active status.
The PFD and MFD have different navigation database versions or
types installed. Crossfill is off. Check the 'Aux-System Status' Page to
determine versions or regions. Also, check the 'Aux-System Status'
Page for a database synchronization function not completed. After
synchronization is complete, power must be turned off, then on.
The PFD and MFD have different obstacle database versions or types
installed. Check the 'Aux-System Status' Page to determine versions
or regions. Also, check the 'Aux-System Status' Page for a database
synchronization function not completed. After synchronization is
complete, power must be turned off, then on.
The PFD and MFD have different terrain database versions or types
installed. Check the 'Aux-System Status' Page to determine versions
or regions. Also, check the 'Aux-System Status' Page for a database
synchronization function not completed. After synchronization is
complete, power must be turned off, then on.
A data path connected to the GDU or the GIA has failed.
This occurs when a newly installed navigation database eliminates
an obsolete approach or arrival used by a stored flight plan. The
obsolete procedure is removed from the flight plan. Update flight
plan with current arrival or approach.
Upon power-up, the system detects that a stored flight plan
waypoint is locked. This occurs when an navigation database update
eliminates an obsolete waypoint. The flight plan cannot find the
specified waypoint and flags this message. This can also occur with
user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any
database,
OR
update the waypoint name/identifier to reflect the new information.
The multimedia card was removed from the bottom card slot of the
MFD. The multimedia card needs to be reinserted.
A failure has been detected in glideslope receiver 1. The system
should be serviced.
190-02622-00 Rev. A