Crew Profiles - Garmin G1000 NXI Cockpit Reference Manual

additional Features
5) Scroll to display the appropriate database information by turning the FMS Knob or
pressing the ENT Key until the applicable database information is shown.
Some quick troubleshooting steps listed below can be performed to find the possible cause
of a failure.
– Ensure the installed Datalink Receiver or Iridium Transceiver has an active subscription
or account.
– Perform a quick check of the circuit breakers to ensure that power is applied to the Data-
link Receiver or Iridium Transceiver.

CREW PRoFILES

System settings may be saved under a crew profile. When the system is powered on, the last
selected crew profile is shown on the MFD Initalization Splash Screen. The system can store
up to 25 profiles; the currently active profile, the amount of memory used, and the amount
of memory available are shown at the top of the System Setup Page in the box labeled 'Crew
Profile'. From here, crew profiles may be created, selected, renamed, or deleted. Crew profiles
may also be exported from the system to an SD card, or imported from an SD card into the
system.
Creating a profile:
1) Select the 'Aux - System Setup 1 or 2' Page.
2) Push the FMS Knob momentarily to activate the flashing cursor.
3) Turn the large FMS Knob to highlight 'Create' in the 'Crew Profile' Box.
4) Press the ENT Key. A 'Create Profile' Window is displayed.
5) Use the FMS Knob to enter a profile name up to 16 characters long and press the ENT
Key. Crew profile names cannot begin with a blank as the first letter.
6) In the next field, use the small FMS Knob to select the desired settings upon which to
base the new profile. Profiles can be created based on Garmin factory defaults, default
profile settings (initially based on Garmin factory defaults unless edited by the pilot), or
other previously created profile settings.
7) Press the ENT Key.
8) With 'Create' highlighted, press the ENT Key to create the profile.
or :
Use the large FMS Knob to select 'Create & Activate' and press the ENT Key to activate
the new profile.
9) To cancel the process, select 'Cancel' with the large FMS Knob and press the ENT Key.
Selecting an active profile:
1) Select the 'Aux - System Setup 1 or 2' Page.
2) Push the FMS Knob momentarily to activate the flashing cursor.
Garmin G1000 NXi Cockpit Reference Guide for the da62
132 190-02622-00 Rev. A